41-2021 - Professional Consulting Services for Linden Lift and Flood Pumping Station (LFPS

D4.1 The Services required under this Contract shall consist of providing detailed design, tendering
and contract administration services for work to upgrade the Linden Flood Pumping Station and
in accordance with the following:
(a) Preliminary Design;
(i) Schematic Design/Program of Requirements completion;
(b) Detailed Design and Specification Development;
(i) Contract Document Preparation;
(ii) Procurement Process;
(c) Contract Administration
(d) Construction Services; and
(e) Post Construction Services.
D4.1.1 The Services required under D4 shall be in accordance with the City’s Project
Management Manual http://winnipeg.ca/infrastructure/asset-managementprogram/
templates-manuals.stm#2 and templates http://winnipeg.ca/infrastructure/assetmanagement-
program/templates-manuals.stm#4 . Notwithstanding the foregoing, the
Consultant is being engaged by the City for its professional expertise; the Consultant shall
bring to the Project Manager’s attention any aspect of the City’s Project Management
Manual or templates which the Consultant is of the opinion is not consistent with good
industry practice.
D4.2 The following shall apply to the Services:
(a) The City of Winnipeg; Water and Waste Department – Electrical Design Guide – Appendix
C
(b) The City of Winnipeg; Water and Waste Department – Identification Standard – Appendix
D
(c) The City of Winnipeg; Water and Waste Department – Automation Design Guide –
Appendix E
D4.3 The following upgrades are required for the Linden LFPS:
(a) Electrical and Automation/Instrumentation
(i) Replace or upgrade all existing electrical equipment including but not limited to:
service entrance equipment, electrical distribution panels, switchgear, circuit
breakers, control panels and motor starters.
(ii) Replace and/or upgrade Remote Terminal Unit with Program Logic Controller
Replace and/or upgrade Level Sensors and Transmitters
(iii) Install and integrate a Motor Control Centre Remove existing resistance typed
reduced voltage starters
(iv) Replacement of electrical distribution system including but not limited to new cabling
and wiring, new interior and exterior lighting, wall receptacles in the Station.
(b) Mechanical
(i) Main floor cooling fan system upgrades
(ii) Drywell ventilation system upgrades
(iii) New heaters as required
(iv) Replace existing seal water valving for flood pumps
(c) Building and Site
(i) Installation of separate access to sanitary sewer chamber
(ii) Replace entry door and frame
(iii) Remove existing window and infill wall opening
(iv) Install thermal barrier over foamed plastic insulation in drywell
(v) Drywell stair safety upgrade
(vi) Localized wood frame wall repair
(vii) Insulate main floor of building
(viii) Repair or replace existing roof, hatch and any associated roof repairs
(d) Substructure
(i) Repair grade beam cracks and/or spalling
(ii) Inject & patch cracks in drywell concrete walls and or beams
(iii) Repair drywell floor for drainage